INTRODUCTION:

The Splash Drone 40A ESC is one of the best ESC that designed for Splash Drone. The circuits and functions are optimized for multirotors, reliable and very fast respond time. It is not only suitable for Splash Drone, but also a great choice for your drone.

OPTO means this ESC lacks of the BEC Circuit, BEC circuit is to convert the battery’s input voltage to 5V for powering the Receiver. Most of the expensive Flight Controllers (e.g. DJI NAZA) has a BEC unit included, so many players will use OPTO ESC to save money and less work load on the ESC. However, if your Flight Controller has NO BEC included, you will need to purchase an UBEC module (5V) to power up the RC Receiver.

FEATURE:

Special core program for multi-rotor controllers greatly improves throttle response
Specially optimized software for excellent compatibility with disc-type motors
All settings except the timing are preset, making usage simple, highly intelligent and adaptive
The twisted-pair design of the throttle signal cable effectively reduces the crosstalk produced in signal transmission and makes flight more stable
Compatible with various flight-control systems and supports a signal frequency of up to 621Hz (Note: all throttle signals over 500Hz are non-standard signals)
Special drive chip has much better MOSFET driving effect than common driving circuit consisted of discrete components
MOSFET with extra-low resistance brings high performance and great current endurance

SPECIFICATION:

Output : Continuous 40A, Burst 60A up to 10 seconds
Input Voltage : 2-6cells lithium battery
BEC : NO BEC
Refresh rate of the throttle signal : at least 400Mhz
Timing : High or Intermediate
Red Black cable length : 120mm
Signal cable length : 260mm
Bullet Connector : 3.5mm
Size : 68 x 25 x 8.7mm
Weight : 26g